,

N Push-Button Variable Attenuator | Economy, DC-3GHz, 5 W, 0-30 dB, 1 dB Step, Unidirectional, Female Input, Female Output, Rectangular, Nickel-Plated Brass Connector

$178.00

+ Free Shipping
SKU: RASP3N5-30-1 Categories: ,

The RASP3N5-30-1 is a N push-button variable attenuator specified from DC to 3 GHz, covering 0-30 dB with a 5 W power rating.

Each press of the button adds one 1 dB step, which makes level changes repeatable and quick during a test sequence.

Typical use is protecting a receiver or spectrum-analyser front end from an over-level signal, or setting a known level into a device under test.

FAQ – What happens above 3 GHz? The attenuation accuracy and VSWR are specified to 3 GHz; beyond that the pad will still attenuate but no longer to the printed accuracy.

FAQ – Will it change my VSWR? A fixed resistive pad actually improves the match seen by both sides, because the attenuating network absorbs reflections. The VSWR figure below is the number to design against.

Connect it the way the title states: input takes the source, output feeds the load. The rating difference between the two ends is deliberate.

The 5 W rating is a continuous rating with the body in free air; derate it if the pad is boxed up against other hot components.

Specified from DC to 3 GHz, the pad keeps its accuracy across the whole band rather than only at spot frequencies.

Key numbers: attenuation 0-30 dB; 5 W power; VSWR 1.3:1 max; 50 ohm impedance; nickel-plated brass body.

FAQ – Can I cascade two pads? Yes, and the dB values add. Check that the first pad’s power rating covers the incoming level and that the second sees a lower power, which it will.

RASP3N5-30-1 datasheet preview – click to view full PDF

Weight0.05 kg
Dimensions8 × 5 × 4 cm
Max Frequency

Series

Reviews

There are no reviews yet.

Be the first to review “N Push-Button Variable Attenuator | Economy, DC-3GHz, 5 W, 0-30 dB, 1 dB Step, Unidirectional, Female Input, Female Output, Rectangular, Nickel-Plated Brass Connector”

Your email address will not be published. Required fields are marked *