Ultra-grade build for a fixed interface pair: RA5002H mates 2.4mm male on one side and 2.4mm male on the other up to 50 GHz. The headline figures are a VSWR of 1.15:1 maximum and an insertion loss of 0.20 dB, all specified across the full DC to 50 GHz band rather than at spot frequencies. With a pin at each end, the part mates two sockets; check both ports are female before ordering. One-piece construction is the point: every extra mating plane is another reflection, and this part replaces a stack of them with a single joint. The straight body keeps the run axial, which is the lowest-loss, lowest-stress way to join two ports. It is built in the Ultra tier, the tightest tolerance class of this interface family, intended for daily precision work.
Specifications
- Interface A: 2.4mm male
- Interface B: 2.4mm male
- Frequency: DC to 50 GHz
- Impedance: 50 ohm
- VSWR: 1.15:1 maximum
- Insertion loss: 0.20 dB maximum
- Body: stainless steel
- Weight: 0.03 kg
- Grade: Ultra
Where it is used
Antenna ranges and shield rooms use it to move between the precision interface at the instrument and the rugged one at the chamber wall. It is the part that lets one instrument port serve devices built around a different interface, which is the daily reality of a shared lab bench.
It is a passive part with no tuning, so it can be swapped in mid-project without re-characterising the rest of the chain.
At 50 GHz the centre pin is a fraction of a millimetre across, so mating care matters as much as the specification.
Compatibility and mating
The 2.4mm interface is its own standard. It will mate 1.85mm, but never SMA or 2.92mm, despite looking close enough to try. Use a torque wrench set to 0.9 N·m and keep the mating plane spotless.
Keep the mating faces clean and dry, and inspect them under a loupe before a critical measurement; most ‘bad’ adapters are dirty ones.
Ordering
Custom builds are possible on the same interface pair: different plating, a different flange pattern or a longer body. State the requirement against this SKU and the factory will confirm what can be held.
Frequently asked questions
Is it 50 or 75 ohm?
This part is 50 ohm. A 75 ohm system needs a matching pad or a 75 ohm part; the two impedances are not interchangeable on a threaded interface of the same size.
Why does the price differ from a standard adapter?
Precision tiers hold tighter tolerances and use better materials and plating, which costs more to machine and to test. The tier is part of the part number, not an option.
Can I mate it with a different precision series?
Only where the standards are mechanically compatible. SMA, 3.5mm and 2.92mm intermate; 2.4mm and 1.85mm intermate; mixing across those two groups damages the precision side.
Does an adapter add loss?
Yes, a small amount. The datasheet gives the maximum insertion loss for this part; at these frequencies it is usually a few tenths of a dB, but it belongs in the budget.
What torque should I use?
About 0.9 N·m for SMA, 2.92mm and 2.4mm interfaces, 1.1 to 1.5 N·m for N. A torque wrench is cheap compared with a damaged calibration port.







Reviews
There are no reviews yet.