RA4011 is what sits between a 1.85mm Male interface and a 2.92mm(K,SK) Female interface when neither cable nor instrument can be changed, rated to 40 GHz.
Specifications
- Frequency: DC to 40 GHz
- Impedance: 50 Ω
- VSWR: 1.2:1 max
- Interfaces: 1.85mm Male / 2.92mm(K,SK) Female
- Body and contact: Stainless Steel
- Grade: Precision
How it is used
Above 26 GHz the adapter is no longer a neutral part: its interface geometry sets how repeatable a connection is. It is normally used to bring a millimetre-wave cable onto a device whose port is a different series, with both interfaces torqued rather than hand-tightened. One plug and one jack in the same body. The plug goes to whichever side presents a jack, and the jack receives a plug; getting that the wrong way round is the commonest ordering mistake on a between-series part, so check which end faces the instrument before the run is built.
What it mates with
2.92mm (K) mates with SMA and 3.5mm as well as with itself, and it is the usual way to reach 40 GHz without changing the SMA thread. 1.85mm goes to 67 GHz; the smaller centre pin is why only a 2.4mm interface will mate with it. Two parts worth comparing are 1.85mm Male to 3.5mm Male Millimeter Wave Adapter (RA3416H) and 1.85mm Male to 3.5mm Female Millimeter Wave Adapter (RA3418H) — same interface family, different grade or body style, so the choice usually comes down to the frequency headroom you need rather than to the price.
A common question
Can this adapter be used below its rated frequency?
Yes, and it will generally measure better there. Running a millimetre-wave adapter at a lower band is harmless; the reverse — running a low-band part near its cutoff — is where the match and the repeatability fall apart.







Reviews
There are no reviews yet.