RA3407 provides the 2.92 mm-to-3.5 mm conversion in one straight body: 50 ohms end to end, DC to 34 GHz.
One end is female and the other male, so match each end against the cable or port it has to meet.
The straight body keeps the signal path axial, the shortest and lowest-reflection layout when the chassis has room. It is the usual answer for a panel cut-out designed around one interface that now has to accept the other.
Up here the adapter is a precision part: alignment, concentricity and a clean mating plane matter more than the cable attached to it. The passivated stainless body holds its dimensions through thousands of mating cycles and resists corrosion on repeatedly handled parts.
Key numbers: VSWR 1.2:1 max; 50 ohm impedance; passivated stainless steel body.
FAQ – What is the worst-case loss? The datasheet below lists maximum insertion loss; the datasheet figure applies across the band.
FAQ – Is it bidirectional? Yes. An adapter is a passive reciprocal two-port, so it works the same way round; only the mechanical mounting differs.
FAQ – What torque should I use? Use the torque recommended for the interface standard of each end. Over-tightening is the usual cause of a damaged mating plane.







Reviews
There are no reviews yet.