RA5004WH carries a 1.85 mm male interface on one end and a 2.4 mm female interface on the other, in a single right-angle housing specified to 50 GHz.
One end is male and the other female, so match each end against the cable or port it has to meet.
Above 40 GHz the adapter is a metrology-grade component; handle the mating plane with the same care as the instrument port itself. The passivated stainless body holds its dimensions through thousands of mating cycles and resists corrosion on repeatedly handled parts.
Key numbers: VSWR 1.25:1 max; insertion loss 0.45 dB max (<= 0.08 sqrt-f GHz); 50 ohm impedance; passivated stainless steel body.
FAQ – What torque should I use? Use the torque recommended for the interface standard of each end. Over-tightening is the usual cause of a damaged mating plane.
FAQ – Is it bidirectional? Yes. An adapter is a passive reciprocal two-port, so it works the same way round; only the mechanical mounting differs.
The 90-degree exit keeps the cable run tight against the chassis, which matters in dense racks and compact fixtures. Systems integrators use it at the boundaries between subsystems, where two vendors rarely agree on the same connector.
FAQ – Will it fit my existing cable? It mates with standard interfaces on both ends. Check the connector family and gender of your cable against each end before ordering.







Reviews
There are no reviews yet.