,

N Coaxial Fixed Attenuator | Professional, DC-6GHz, 10 W, 1-60 dB, Bidirectional, Male-Male, Round, Tri-metal Plated Brass Connector

$189.00

+ Free Shipping
SKU: R6N10MM-XX Categories: ,

Rated 10 W and specified from DC to 6 GHz, R6N10MM-XX inserts 1-60 dB into a N line as a fixed pad.

A fixed pad trades flexibility for certainty: the value is what it says, every time, across the band.

Typical use is protecting a receiver or spectrum-analyser front end from an over-level signal, or setting a known level into a device under test.

FAQ – Can I cascade two pads? Yes, and the dB values add. Check that the first pad’s power rating covers the incoming level and that the second sees a lower power, which it will.

FAQ – What happens above 6 GHz? The attenuation accuracy and VSWR are specified to 6 GHz; beyond that the pad will still attenuate but no longer to the printed accuracy.

Either connector can face the source: the symmetric construction attenuates identically in both directions.

At 10 W of dissipation the body is sized to take continuous input at that level; the resistive element and its heat path are matched to it, which is why the rating is a hard number rather than a guideline.

The DC to 6 GHz range is the accuracy band: inside it the attenuation stays within the printed tolerance and the VSWR within its figure.

Key numbers: attenuation 1-60 dB; 10 W power; VSWR 1.2:1 max; 50 ohm impedance; tri-metal plated brass body.

FAQ – Will it change my VSWR? A fixed resistive pad actually improves the match seen by both sides, because the attenuating network absorbs reflections. The VSWR figure below is the number to design against.

R6N10MM-XX datasheet preview – click to view full PDF

Weight 0.05 kg
Dimensions 8 × 5 × 4 cm
Max Frequency

Reviews

There are no reviews yet.

Be the first to review “N Coaxial Fixed Attenuator | Professional, DC-6GHz, 10 W, 1-60 dB, Bidirectional, Male-Male, Round, Tri-metal Plated Brass Connector”

Your email address will not be published. Required fields are marked *