RASP3S5-90-1 is the SMA push-button variable attenuator in this range: 0-90 dB of attenuation, 5 W dissipation, specified DC to 3 GHz.
The pad is adjusted in 1 dB increments, so the level can be dialled in without swapping parts; a click per step keeps the setting readable on a busy bench.
Typical use is protecting a receiver or spectrum-analyser front end from an over-level signal, or setting a known level into a device under test.
FAQ – Will it change my VSWR? A fixed resistive pad actually improves the match seen by both sides, because the attenuating network absorbs reflections. The VSWR figure below is the number to design against.
FAQ – What happens above 3 GHz? The attenuation accuracy and VSWR are specified to 3 GHz; beyond that the pad will still attenuate but no longer to the printed accuracy.
Connect it the way the title states: input takes the source, output feeds the load. The rating difference between the two ends is deliberate.
The 5 W rating is a continuous rating with the body in free air; derate it if the pad is boxed up against other hot components.
Specified from DC to 3 GHz, the pad keeps its accuracy across the whole band rather than only at spot frequencies.
Key numbers: attenuation 0-90 dB; 5 W power; VSWR 1.4:1 max; 50 ohm impedance; nickel-plated brass body.
FAQ – Can I cascade two pads? Yes, and the dB values add. Check that the first pad’s power rating covers the incoming level and that the second sees a lower power, which it will.







Reviews
There are no reviews yet.