RAL06D33 provides the 4.3-10-to-N conversion in one straight body: 50 ohms end to end, DC to 6 GHz.
Both ends are female, so it joins two ports or cables of the same sex; the part number states the pairing.
Key numbers: VSWR 1.2:1 max; 50 ohm impedance; tri-metal plated brass body.
FAQ – Is it bidirectional? Yes. An adapter is a passive reciprocal two-port, so it works the same way round; only the mechanical mounting differs.
FAQ – What torque should I use? Use the torque recommended for the interface standard of each end. Over-tightening is the usual cause of a damaged mating plane.
The straight body keeps the signal path axial, the shortest and lowest-reflection layout when the chassis has room. It shows up most often in lab test set-ups and production fixtures, where one port type has to serve devices terminated in the other.
Through this band the adapter behaves almost ideally; above it, concentricity starts to show up in the VSWR plot. The tri-metal plating stack on the brass body balances conductivity, wear resistance and corrosion protection.
FAQ – What is the worst-case loss? The datasheet below lists maximum insertion loss; the datasheet figure applies across the band.







Reviews
There are no reviews yet.