,

BNC Male to BNC Female Right Angle 90° Adapter | Economy, DC-4GHz, Brass with Tri-metal Plating

$22.00

+ Free Shipping
SKU: RA04B03W-TBA Categories: ,

RA04B03W-TBA is BNC male-to-female adapter in a right-angle body, rated 50 ohms from DC through 4 GHz.

One end is male and the other female, so match each end against the cable or port it has to meet.

Through this band the adapter behaves almost ideally; above it, concentricity starts to show up in the VSWR plot. The tri-metal plating stack on the brass body balances conductivity, wear resistance and corrosion protection.

Key numbers: VSWR 1.25:1 max; 50 ohm impedance; tri-metal plated brass body.

FAQ – What torque should I use? Use the torque recommended for the interface standard of each end. Over-tightening is the usual cause of a damaged mating plane.

FAQ – Can I run it above 4 GHz? The part is specified to 4 GHz. Above that the VSWR and loss figures are no longer guaranteed, so treat it as out of band.

The 90-degree exit keeps the cable run tight against the chassis, which matters in dense racks and compact fixtures. Common applications are test jigs, instrument front ends and module-to-module links inside an enclosure.

FAQ – What is the worst-case loss? The datasheet below lists maximum insertion loss; the datasheet figure applies across the band.

RA04B03W-TBA datasheet preview – click to view full PDF

Weight 0.03 kg
Dimensions 6 × 3 × 3 cm
Connector Type

Max Frequency

Series

Reviews

There are no reviews yet.

Be the first to review “BNC Male to BNC Female Right Angle 90° Adapter | Economy, DC-4GHz, Brass with Tri-metal Plating”

Your email address will not be published. Required fields are marked *