,

NMD 1.0 male to 1.0mm female thru-wall millimeter-wave adapter Precision type, NMD reinforced, DC-110GHz, stainless steel beryllium copper gold-plated – RA11004Y

$28.00

+ Free Shipping
SKU: RA11004Y Categories: ,

The RA11004Y joins an NMD 1.0 male interface to a 1.0mm thru-wall female interface in one straight body specified from DC to 110 GHz.

This is the interface you need when the other end is a network-analyser test port or a calibration kit. Standard 1.0mm thru-wall connectors look similar but are not interchangeable with the NMD geometry.

FAQ – Can I run it above 110 GHz? The part is specified to 110 GHz. Above that the VSWR and loss figures are no longer guaranteed, so treat it as out of band.

FAQ – Will it fit my existing cable? It mates with standard interfaces on both ends. Check the connector family and gender of your cable against each end before ordering.

The 110 GHz rating matches the band where these test-port interfaces are normally gauged and used, from DC upward.

Key numbers: VSWR 1.35:1 max; 50 ohm impedance; passivated stainless steel body.

It belongs at the boundary between the analyser and the outside world: NMD on the port side, standard interface on the cable side, so wear lands on the replaceable adapter rather than the test port.

FAQ – What is the worst-case loss? The datasheet below lists maximum insertion loss; the see datasheet figure applies across the band.

This body belongs to our 1.0 mm adapter range.

RA11004Y datasheet preview – click to view full PDF

Weight 0.03 kg
Dimensions 6 × 3 × 3 cm
Connector Type

,

Max Frequency

Series

Reviews

There are no reviews yet.

Be the first to review “NMD 1.0 male to 1.0mm female thru-wall millimeter-wave adapter Precision type, NMD reinforced, DC-110GHz, stainless steel beryllium copper gold-plated – RA11004Y”

Your email address will not be published. Required fields are marked *