,

1.0mm Female to 1.85mm Male Millimeter Wave Adapter Ultra, DC-67GHz, Stainless Steel – RA6706H

$150.00

+ Free Shipping
SKU: RA6706H Categories: ,

RA6706H carries a 1.0 mm female interface on one end and a 1.85 mm male interface on the other, in a single straight housing specified to 67 GHz.

One end is female and the other male, so match each end against the cable or port it has to meet.

This is millimetre-wave territory: a damaged mating plane or a speck of dust measurably raises the return loss. The passivated stainless body holds its dimensions through thousands of mating cycles and resists corrosion on repeatedly handled parts.

Key numbers: VSWR 1.25:1 max; insertion loss 0.40 dB max (0.06 x sqrt(f) GHz); 50 ohm impedance; passivated stainless steel body.

FAQ – What is the worst-case loss? The datasheet below lists maximum insertion loss; the 0.40 figure applies across the band.

FAQ – Can I run it above 67 GHz? The part is specified to 67 GHz. Above that the VSWR and loss figures are no longer guaranteed, so treat it as out of band.

The straight body keeps the signal path axial, the shortest and lowest-reflection layout when the chassis has room. Systems integrators use it at the boundaries between subsystems, where two vendors rarely agree on the same connector.

FAQ – Will it fit my existing cable? It mates with standard interfaces on both ends. Check the connector family and gender of your cable against each end before ordering.

This body belongs to our 1.0 mm adapter range, and the other end matches our 1.85 mm adapters.

RA6706H datasheet preview – click to view full PDF

Weight 0.03 kg
Dimensions 6 × 3 × 3 cm
Connector Type

,

Max Frequency

Series

Reviews

There are no reviews yet.

Be the first to review “1.0mm Female to 1.85mm Male Millimeter Wave Adapter Ultra, DC-67GHz, Stainless Steel – RA6706H”

Your email address will not be published. Required fields are marked *