RA3418 carries a 1.85 mm male interface on one end and a 3.5 mm female interface on the other, in a single straight housing specified to 34 GHz.
One end is male and the other female, so match each end against the cable or port it has to meet.
Key numbers: VSWR 1.2:1 max; 50 ohm impedance; passivated stainless steel body.
FAQ – Will it fit my existing cable? It mates with standard interfaces on both ends. Check the connector family and gender of your cable against each end before ordering.
FAQ – What torque should I use? Use the torque recommended for the interface standard of each end. Over-tightening is the usual cause of a damaged mating plane.
The straight body keeps the signal path axial, the shortest and lowest-reflection layout when the chassis has room. It is the usual answer for a panel cut-out designed around one interface that now has to accept the other.
Up here the adapter is a precision part: alignment, concentricity and a clean mating plane matter more than the cable attached to it. The passivated stainless body holds its dimensions through thousands of mating cycles and resists corrosion on repeatedly handled parts.
FAQ – Is it bidirectional? Yes. An adapter is a passive reciprocal two-port, so it works the same way round; only the mechanical mounting differs.







Reviews
There are no reviews yet.