A straight 50 ohm part, RA5003 converts a 2.4 mm female interface to a second 2.4 mm male interface across the DC to 50 GHz band.
One end is female and the other male, so match each end against the cable or port it has to meet.
FAQ – Will it fit my existing cable? It mates with standard interfaces on both ends. Check the connector family and gender of your cable against each end before ordering.
The straight body keeps the signal path axial, the shortest and lowest-reflection layout when the chassis has room. Typical use is a bench where an instrument port has to meet a device built around the other interface, or a rack panel that needs one series converted at the wall.
Above 40 GHz the adapter is a metrology-grade component; handle the mating plane with the same care as the instrument port itself. The passivated stainless body holds its dimensions through thousands of mating cycles and resists corrosion on repeatedly handled parts.
Key numbers: VSWR 1.2:1 max; 50 ohm impedance; passivated stainless steel body.
FAQ – Is it bidirectional? Yes. An adapter is a passive reciprocal two-port, so it works the same way round; only the mechanical mounting differs.
FAQ – What torque should I use? Use the torque recommended for the interface standard of each end. Over-tightening is the usual cause of a damaged mating plane.







Reviews
There are no reviews yet.