The RT425PM terminates a 4.3-10 line in 50 ohms up to 4 GHz, with a 25 W dissipation rating. The headline figures are a VSWR of 1.2:1 maximum and 25 W of dissipation, all specified across the full DC to 4 GHz band rather than at spot frequencies. The body screws straight onto the port and needs no mounting hardware, which is why a termination can live on a spare port indefinitely. It is built in the Professional tier, the standard professional build for laboratory and production use.
Specifications
- Interface: 4.3-10, male
- Power: 25 W
- Frequency: DC to 4 GHz
- Impedance: 50 ohm
- VSWR: 1.2:1 maximum
- Body: ternary alloy plated brass
- Centre contact: gold plating on the contact surfaces
- Weight: 0.08 kg
- Grade: Professional
Where it is used
Combiners and switches need every unused port terminated; this is the part that does it without disturbing the match. It parks an unused port in a matched state, which keeps reflections out of the rest of the system.
It is also the part that protects a transmitter from itself: without a load, an unkeyed amplifier sees an open circuit and the output stage takes the strain.
At 4 GHz the electrical size of the body is small, so a compact in-line construction holds its match without tuning.
Compatibility and mating
It mates standard 4.3-10 connectors. The interface was designed to be compact and PIM-stable, which depends on a properly torqued joint and clean contact surfaces, not on how hard the nut is turned.
The interface follows the series standard, so the termination fits any cable or port of that type; what changes between loads is the power handling and the body, not the mating plane.
Keep the mating faces clean and dry, and inspect them under a loupe before a critical measurement; most ‘bad’ adapters are dirty ones.
Ordering
Every unit ships with its datasheet, and the outline drawing in it is the reference for panel cut-outs and mounting hole spacing. Check it before designing a fixture around the part.
Frequently asked questions
Will it protect my receiver?
It protects the port from reflections, not from over-voltage. For front-end protection use a limiter, not a load.
Load or termination – same thing?
Yes. Both names mean a 50 ohm resistive element in a connector body that absorbs the power sent to it.
Can I use it outdoors?
Only with a weatherproofed interface. The body itself is metal, but the mating plane is not sealed unless stated.
Does orientation matter?
For finned bodies, yes: mount with the fins vertical and in free air, or the rating drops.
Can it stay on a port permanently?
At bench power levels yes. At high power, check the body temperature and give the fins room.



![[Premium Pick] N Male Coaxial Termination | Economy, DC-18GHz, 2 W, Round, Nickel-Plated Brass Connector](https://rfspect.com/wp-content/uploads/2026/09/RT182NM-NBA.png)



Reviews
There are no reviews yet.