,

SMA Female Coaxial Termination | Professional, DC-12.4GHz, 10 W, Round, Passivated Stainless Steel Connector

$141.00

+ Free Shipping
SKU: RT1210SF Categories: ,

RT1210SF is the standard SMA load in this range: 10 W rating, female interface, DC to 12.4 GHz.

The compact in-line body is appropriate here: the element dissipates its rated power without needing fins, so the part stays small and unobtrusive on the port.

The round in-line body suits panel jacks and bench use, where it hangs on the port and convects freely.

The DC to 12.4 GHz specification is the band over which the element is guaranteed matched; treat anything above it as out of tolerance.

Key numbers: 10 W dissipation; VSWR 1.25:1 max; 50 ohm impedance; DC to 12.4 GHz; passivated stainless steel body.

Typical use is leaving an unused port terminated, dummy-loading a transmitter during alignment, or providing a stable 50 ohm sink at the far end of a line under test.

FAQ – What VSWR should I expect? The figure in the specs below is the guaranteed maximum across the band; a healthy termination typically measures better on the bench.

FAQ – Does mounting orientation matter? For the finned bodies, yes: they are rated to convect with the fins vertical. Enclosing one or mounting it against a panel cuts the rating.

FAQ – Is ‘dummy load’ something different again? It is a third name for the same component: a connectorised resistor that soaks up RF power instead of reflecting it.

RT1210SF datasheet preview – click to view full PDF

Weight 0.08 kg
Dimensions 8 × 4 × 4 cm
Connector Type

Max Frequency

Reviews

There are no reviews yet.

Be the first to review “SMA Female Coaxial Termination | Professional, DC-12.4GHz, 10 W, Round, Passivated Stainless Steel Connector”

Your email address will not be published. Required fields are marked *