The RT1215SM is a SMA coaxial termination: male interface, 15 W of dissipation, specified from DC to 12.4 GHz.
A medium-power element needs more heat path than a bench pad, so the body is extended or finned and rated for continuous free-air operation.
The round in-line body suits panel jacks and bench use, where it hangs on the port and convects freely.
The DC to 12.4 GHz specification is the band over which the element is guaranteed matched; treat anything above it as out of tolerance.
Key numbers: 15 W dissipation; VSWR 1.3:1 max; 50 ohm impedance; DC to 12.4 GHz; passivated stainless steel body.
Typical use is leaving an unused port terminated, dummy-loading a transmitter during alignment, or providing a stable 50 ohm sink at the far end of a line under test.
FAQ – Does mounting orientation matter? For the finned bodies, yes: they are rated to convect with the fins vertical. Enclosing one or mounting it against a panel cuts the rating.
FAQ – What VSWR should I expect? The figure in the specs below is the guaranteed maximum across the band; a healthy termination typically measures better on the bench.
FAQ – Is ‘dummy load’ something different again? It is a third name for the same component: a connectorised resistor that soaks up RF power instead of reflecting it.






![[Premium Pick] 2.92mm(K,SK) Male Millimeter-Wave Coaxial Termination | Professional, DC-40GHz, 2 W, Round, Passivated Stainless Steel Connector](https://rfspect.com/wp-content/uploads/2026/09/RT402MX.png)
Reviews
There are no reviews yet.