RT122SF is the standard SMA load in this range: 2 W rating, female interface, DC to 12.4 GHz.
At this power level a compact in-line body is enough; the load can stay on a port permanently without overheating the enclosure.
Key numbers: 2 W dissipation; VSWR 1.25:1 max; 50 ohm impedance; DC to 12.4 GHz; passivated stainless steel body.
Typical use is leaving an unused port terminated, dummy-loading a transmitter during alignment, or providing a stable 50 ohm sink at the far end of a line under test.
FAQ – Is ‘dummy load’ something different again? It is a third name for the same component: a connectorised resistor that soaks up RF power instead of reflecting it.
FAQ – Does mounting orientation matter? For the finned bodies, yes: they are rated to convect with the fins vertical. Enclosing one or mounting it against a panel cuts the rating.
The round in-line body suits panel jacks and bench use, where it hangs on the port and convects freely.
From DC to 12.4 GHz the termination holds its VSWR figure; above the limit the match degrades, which matters if you rely on the load to absorb reflected power.
FAQ – What VSWR should I expect? The figure in the specs below is the guaranteed maximum across the band; a healthy termination typically measures better on the bench.







Reviews
There are no reviews yet.