,

L29 (DIN 7/16) Male to L29 (DIN 7/16) Female Right Angle 90° Adapter | Economy, DC-3GHz, Brass with Tri-metal Plating

$40.00

+ Free Shipping
SKU: RA03D01W Categories: ,

Mating an L29 (DIN 7/16) male interface to a second L29 (DIN 7/16) female interface, RA03D01W is a right-angle 50 ohm adapter built for DC to 3 GHz work.

One end is male and the other female, so match each end against the cable or port it has to meet.

Key numbers: VSWR 1.15:1 max; 50 ohm impedance; tri-metal plated brass body.

FAQ – What torque should I use? Use the torque recommended for the interface standard of each end. Over-tightening is the usual cause of a damaged mating plane.

FAQ – What is the worst-case loss? The datasheet below lists maximum insertion loss; the datasheet figure applies across the band.

The 90-degree exit keeps the cable run tight against the chassis, which matters in dense racks and compact fixtures. Engineers reach for it when an existing cable assembly has to mate with a device built around the other connector, without rebuilding the harness.

DC to this band covers video through S-band work, where the interface geometry is comfortable and return loss is dominated by the mating surfaces. The tri-metal plating stack on the brass body balances conductivity, wear resistance and corrosion protection.

FAQ – Can I run it above 3 GHz? The part is specified to 3 GHz. Above that the VSWR and loss figures are no longer guaranteed, so treat it as out of band.

RA03D01W datasheet preview – click to view full PDF

Weight 0.03 kg
Dimensions 6 × 3 × 3 cm
Connector Type

,

Max Frequency

Series

Reviews

There are no reviews yet.

Be the first to review “L29 (DIN 7/16) Male to L29 (DIN 7/16) Female Right Angle 90° Adapter | Economy, DC-3GHz, Brass with Tri-metal Plating”

Your email address will not be published. Required fields are marked *