R8S30FFU-XX is the SMA Medium-Power fixed attenuator in this range: 1-40 dB of attenuation, 30 W dissipation, specified DC to 8.5 GHz.
A fixed pad trades flexibility for certainty: the value is what it says, every time, across the band.
Connect it the way the title states: input takes the source, output feeds the load. The rating difference between the two ends is deliberate.
The 30 W rating is a continuous rating with the body in free air; derate it if the pad is boxed up against other hot components.
The DC to 8.5 GHz range is the accuracy band: inside it the attenuation stays within the printed tolerance and the VSWR within its figure.
Key numbers: attenuation 1-40 dB; 30 W power; VSWR 1.2:1 max; 50 ohm impedance; passivated stainless steel body.
Typical use is protecting a receiver or spectrum-analyser front end from an over-level signal, or setting a known level into a device under test.
FAQ – What happens above 8.5 GHz? The attenuation accuracy and VSWR are specified to 8.5 GHz; beyond that the pad will still attenuate but no longer to the printed accuracy.
FAQ – Can I cascade two pads? Yes, and the dB values add. Check that the first pad’s power rating covers the incoming level and that the second sees a lower power, which it will.
FAQ – Will it change my VSWR? A fixed resistive pad actually improves the match seen by both sides, because the attenuating network absorbs reflections. The VSWR figure below is the number to design against.







Reviews
There are no reviews yet.