, ,

BNC Male to N Female Adapter | Ultra, DC-18GHz, Stainless Steel & Beryllium Copper, Nickel Plated

$137.00

+ Free Shipping
SKU: RA06B04 Categories: , ,

Mating a BNC male interface to an N female interface, RA06B04 is a straight 50 ohm adapter built for DC to 18 GHz work.

One end is male and the other female, so match each end against the cable or port it has to meet.

Key numbers: VSWR 1.2:1 max; insertion loss 0.20 dB max (<= 0.04 sqrt-f GHz); 50 ohm impedance; metal body.

FAQ – What torque should I use? Use the torque recommended for the interface standard of each end. Over-tightening is the usual cause of a damaged mating plane.

FAQ – Can I run it above 18 GHz? The part is specified to 18 GHz. Above that the VSWR and loss figures are no longer guaranteed, so treat it as out of band.

The straight body keeps the signal path axial, the shortest and lowest-reflection layout when the chassis has room. Systems integrators use it at the boundaries between subsystems, where two vendors rarely agree on the same connector.

DC to 18 GHz covers the great majority of lab work, from baseband through Ku-band.

FAQ – What is the worst-case loss? The datasheet below lists maximum insertion loss; the 0.20 figure applies across the band.

RA06B04 datasheet preview – click to view full PDF

Weight 0.03 kg
Dimensions 6 × 3 × 3 cm
Connector Type

,

Max Frequency

Series

Reviews

There are no reviews yet.

Be the first to review “BNC Male to N Female Adapter | Ultra, DC-18GHz, Stainless Steel & Beryllium Copper, Nickel Plated”

Your email address will not be published. Required fields are marked *