,

2.92mm(K,SK) Male to 2.92mm(K,SK) Female Millimeter-Wave Ultra-Low Loss Phase-Stable Cable Assembly | Precision, Low Loss, DC-40GHz, with RCA360 Cable

$198.00

+ Free Shipping

RCA360-KMKF-L carries a 2.92 mm male interface on one end and a 2.92mm Millimeter-Wave Ultra-Low Loss Phase-Stable Cable Assembly female interface on the other, in a single straight housing specified to 40 GHz.

One end is male and the other female, so match each end against the cable or port it has to meet.

FAQ – Can I run it above 40 GHz? The part is specified to 40 GHz. Above that the VSWR and loss figures are no longer guaranteed, so treat it as out of band.

FAQ – What is the worst-case loss? The datasheet below lists maximum insertion loss; the 3.06 figure applies across the band.

The straight body keeps the signal path axial, the shortest and lowest-reflection layout when the chassis has room. It shows up most often in lab test set-ups and production fixtures, where one port type has to serve devices terminated in the other.

Up here the adapter is a precision part: alignment, concentricity and a clean mating plane matter more than the cable attached to it.

Key numbers: VSWR 1.3:1 max; 50 ohm impedance; metal body.

FAQ – Is it bidirectional? Yes. An adapter is a passive reciprocal two-port, so it works the same way round; only the mechanical mounting differs.

RCA360-KMKF-L datasheet preview – click to view full PDF

Connector Type

Max Frequency

Series

, , ,

Reviews

There are no reviews yet.

Be the first to review “2.92mm(K,SK) Male to 2.92mm(K,SK) Female Millimeter-Wave Ultra-Low Loss Phase-Stable Cable Assembly | Precision, Low Loss, DC-40GHz, with RCA360 Cable”

Your email address will not be published. Required fields are marked *