The RT1210NF is a N coaxial termination: female interface, 10 W of dissipation, specified from DC to 12.4 GHz.
At this power level a compact in-line body is enough; the load can stay on a port permanently without overheating the enclosure.
Round in-line construction keeps the part at home on a patch panel or the end of a test lead.
The DC to 12.4 GHz specification is the band over which the element is guaranteed matched; treat anything above it as out of tolerance.
Key numbers: 10 W dissipation; VSWR 1.25:1 max; 50 ohm impedance; DC to 12.4 GHz; ternary alloy plated brass body.
Typical use is leaving an unused port terminated, dummy-loading a transmitter during alignment, or providing a stable 50 ohm sink at the far end of a line under test.
FAQ – Does mounting orientation matter? For the finned bodies, yes: they are rated to convect with the fins vertical. Enclosing one or mounting it against a panel cuts the rating.
FAQ – What VSWR should I expect? The figure in the specs below is the guaranteed maximum across the band; a healthy termination typically measures better on the bench.
FAQ – Is ‘dummy load’ something different again? It is a third name for the same component: a connectorised resistor that soaks up RF power instead of reflecting it.




![[Premium Pick] SMA Male Coaxial Termination | Professional, DC-26.5GHz, 2 W, Round, Passivated Stainless Steel Connector](https://rfspect.com/wp-content/uploads/2026/09/RT272SM.png)

![[Premium Pick] 2.92mm(K,SK) Male Millimeter-Wave Coaxial Termination | Professional, DC-40GHz, 2 W, Round, Passivated Stainless Steel Connector](https://rfspect.com/wp-content/uploads/2026/09/RT402MX.png)
Reviews
There are no reviews yet.