RT125SF terminates a SMA line in 50 ohms through a female interface, taking 5 W from DC to 12.4 GHz.
The compact in-line body is appropriate here: the element dissipates its rated power without needing fins, so the part stays small and unobtrusive on the port.
The DC to 12.4 GHz specification is the band over which the element is guaranteed matched; treat anything above it as out of tolerance.
Key numbers: 5 W dissipation; VSWR 1.25:1 max; 50 ohm impedance; DC to 12.4 GHz; passivated stainless steel body.
Typical use is leaving an unused port terminated, dummy-loading a transmitter during alignment, or providing a stable 50 ohm sink at the far end of a line under test.
FAQ – Does mounting orientation matter? For the finned bodies, yes: they are rated to convect with the fins vertical. Enclosing one or mounting it against a panel cuts the rating.
FAQ – What VSWR should I expect? The figure in the specs below is the guaranteed maximum across the band; a healthy termination typically measures better on the bench.
The cylindrical body is the classic bench shape: it screws straight onto the port and needs no mounting hardware.
FAQ – Is ‘dummy load’ something different again? It is a third name for the same component: a connectorised resistor that soaks up RF power instead of reflecting it.







Reviews
There are no reviews yet.