,

1.85mm Female Millimeter-Wave Coaxial Termination | Professional, DC-67GHz, 2 W, Round, Passivated Stainless Steel Connector

$746.00

+ Free Shipping
SKU: RT672FX Categories: ,

RT672FX terminates a 1.85mm line in 50 ohms through a female interface, taking 2 W from DC to 67 GHz.

At this power level a compact in-line body is enough; the load can stay on a port permanently without overheating the enclosure.

FAQ – Does mounting orientation matter? For the finned bodies, yes: they are rated to convect with the fins vertical. Enclosing one or mounting it against a panel cuts the rating.

FAQ – Is ‘dummy load’ something different again? It is a third name for the same component: a connectorised resistor that soaks up RF power instead of reflecting it.

The round in-line body suits panel jacks and bench use, where it hangs on the port and convects freely.

The DC to 67 GHz specification is the band over which the element is guaranteed matched; treat anything above it as out of tolerance.

Key numbers: 2 W dissipation; VSWR 1.3:1 max; 50 ohm impedance; DC to 67 GHz; passivated stainless steel body.

It belongs on any port that would otherwise bounce energy back down the line: spare outputs, alignment set-ups, and the output side of amplifiers being characterised.

FAQ – What VSWR should I expect? The figure in the specs below is the guaranteed maximum across the band; a healthy termination typically measures better on the bench.

RT672FX datasheet preview – click to view full PDF

Weight 0.08 kg
Dimensions 8 × 4 × 4 cm
Connector Type

Max Frequency

Reviews

There are no reviews yet.

Be the first to review “1.85mm Female Millimeter-Wave Coaxial Termination | Professional, DC-67GHz, 2 W, Round, Passivated Stainless Steel Connector”

Your email address will not be published. Required fields are marked *