RA40SA13 is a precision 2.4mm Female-to-SSMA Male adapter. Its job is unglamorous and constant — keep the interface pair correct without adding a length of cable.
Specifications
- Frequency: DC to 40 GHz
- Impedance: 50 Ω
- VSWR: 1.2:1 max
- Interfaces: 2.4mm Female / SSMA Male
- Body and contact: Stainless Steel
- Grade: Precision
Where it fits in a setup
On a probe station or in an antenna range the adapter is the last mechanical interface before the device, so its body length and its torque window both matter as much as the VSWR figure printed on the datasheet. One jack and one plug, in that order. The jack is the end that takes a cable plug, the plug is the end that goes into a fixed port; if the fixture is wired the other way round the adapter will not seat, and forcing it is how a centre contact gets pushed back.
Mating and compatibility
2.4mm mates only with 1.85mm and other 2.4mm parts. It deliberately does not mate with SMA, which is what stops a 50 GHz port being damaged by a mis-threaded connector. SSMA is a scaled-down SMA: same 50 Ω air-and-bead construction, smaller body, higher usable frequency. It mates only with SSMA, never with SMA — the smaller geometry is what buys the extra band. Two parts worth comparing are 2.4mm Female to 2.4mm Female 4-Hole Flange Millimeter-Wave Adapter (RA5001FH) and 2.4mm Female to 2.4mm Female Millimeter-Wave Adapter (RA5001H) — same interface family, different grade or body style, so the choice usually comes down to the frequency headroom you need rather than to the price.
A common question
Can this adapter be used below its rated frequency?
Yes, and it will generally measure better there. Running a millimetre-wave adapter at a lower band is harmless; the reverse — running a low-band part near its cutoff — is where the match and the repeatability fall apart.







Reviews
There are no reviews yet.