,

4.3-10 Male to N Female Adapter | Precision, Low PIM, DC-6GHz, Brass with Tri-metal Plating

$60.00

+ Free Shipping
SKU: RAL06D32 Categories: ,

Mating a 4.3-10 male interface to an N female interface, RAL06D32 is a straight 50 ohm adapter built for DC to 6 GHz work.

One end is male and the other female, so match each end against the cable or port it has to meet.

FAQ – Is it bidirectional? Yes. An adapter is a passive reciprocal two-port, so it works the same way round; only the mechanical mounting differs.

It is built as a low-PIM part, with plated interfaces chosen to keep passive intermodulation down in multi-carrier systems.

The straight body keeps the signal path axial, the shortest and lowest-reflection layout when the chassis has room. It also earns its keep as a sacrificial adapter on an instrument port: letting wear land on the adapter instead of the calibrated connector.

Through this band the adapter behaves almost ideally; above it, concentricity starts to show up in the VSWR plot. The tri-metal plating stack on the brass body balances conductivity, wear resistance and corrosion protection.

Key numbers: VSWR 1.2:1 max; 50 ohm impedance; tri-metal plated brass body.

FAQ – What torque should I use? Use the torque recommended for the interface standard of each end. Over-tightening is the usual cause of a damaged mating plane.

FAQ – What is the worst-case loss? The datasheet below lists maximum insertion loss; the datasheet figure applies across the band.

RAL06D32 datasheet preview – click to view full PDF

Weight 0.03 kg
Dimensions 6 × 3 × 3 cm
Connector Type

,

Max Frequency

Series

Reviews

There are no reviews yet.

Be the first to review “4.3-10 Male to N Female Adapter | Precision, Low PIM, DC-6GHz, Brass with Tri-metal Plating”

Your email address will not be published. Required fields are marked *