,

BNC Female to BNC Female Tee Adapter | Economy, DC-4GHz, Nickel-Plated Brass

$15.00

+ Free Shipping
SKU: RA04B01T-NBA Categories: ,

The RA04B01T-NBA is a 50 ohm coaxial adapter that joins a BNC female interface to a BNC Tee female interface in one straight body, specified from DC to 4 GHz.

Both ends are female, so it joins two ports or cables of the same sex; the part number states the pairing.

FAQ – Can I run it above 4 GHz? The part is specified to 4 GHz. Above that the VSWR and loss figures are no longer guaranteed, so treat it as out of band.

FAQ – What is the worst-case loss? The datasheet below lists maximum insertion loss; the datasheet figure applies across the band.

The straight body keeps the signal path axial, the shortest and lowest-reflection layout when the chassis has room. Typical use is a bench where an instrument port has to meet a device built around the other interface, or a rack panel that needs one series converted at the wall.

Through this band the adapter behaves almost ideally; above it, concentricity starts to show up in the VSWR plot. The plated brass body keeps cost down while holding contact resistance stable over repeated mating.

Key numbers: VSWR 1.3:1 max; 50 ohm impedance; nickel-plated brass body.

FAQ – What torque should I use? Use the torque recommended for the interface standard of each end. Over-tightening is the usual cause of a damaged mating plane.

RA04B01T-NBA datasheet preview – click to view full PDF

Weight0.03 kg
Dimensions6 × 3 × 3 cm
Connector Type

Max Frequency

Series

Reviews

There are no reviews yet.

Be the first to review “BNC Female to BNC Female Tee Adapter | Economy, DC-4GHz, Nickel-Plated Brass”

Your email address will not be published. Required fields are marked *