,

L29 (DIN 7/16) Female to 4.3-10 Male Adapter | Precision, Low PIM, DC-6GHz, Brass with Tri-metal Plating

$69.00

+ Free Shipping
SKU: RAL06D13 Categories: ,

The RAL06D13 is a 50 ohm coaxial adapter that joins an L29 (DIN 7/16) female interface to a 4.3-10 male interface in one straight body, specified from DC to 6 GHz.

One end is female and the other male, so match each end against the cable or port it has to meet.

FAQ – Is it bidirectional? Yes. An adapter is a passive reciprocal two-port, so it works the same way round; only the mechanical mounting differs.

It is built as a low-PIM part, with plated interfaces chosen to keep passive intermodulation down in multi-carrier systems.

The straight body keeps the signal path axial, the shortest and lowest-reflection layout when the chassis has room. Systems integrators use it at the boundaries between subsystems, where two vendors rarely agree on the same connector.

Through this band the adapter behaves almost ideally; above it, concentricity starts to show up in the VSWR plot. The tri-metal plating stack on the brass body balances conductivity, wear resistance and corrosion protection.

Key numbers: VSWR 1.2:1 max; 50 ohm impedance; tri-metal plated brass body.

FAQ – What torque should I use? Use the torque recommended for the interface standard of each end. Over-tightening is the usual cause of a damaged mating plane.

FAQ – What is the worst-case loss? The datasheet below lists maximum insertion loss; the datasheet figure applies across the band.

RAL06D13 datasheet preview – click to view full PDF

Weight 0.03 kg
Dimensions 6 × 3 × 3 cm
Connector Type

, ,

Max Frequency

Series

Reviews

There are no reviews yet.

Be the first to review “L29 (DIN 7/16) Female to 4.3-10 Male Adapter | Precision, Low PIM, DC-6GHz, Brass with Tri-metal Plating”

Your email address will not be published. Required fields are marked *