,

SMA Coaxial Fixed Attenuator | Professional, DC-18GHz, 10 W, 1-40 dB, Bidirectional, Male-Female, Round, Stainless Steel Connector

$283.00

+ Free Shipping
SKU: R18S10-XX Categories: ,

R18S10-XX is a coaxial fixed pad: SMA interfaces, 1-40 dB, 10 W, DC to 18 GHz. The headline figures are a VSWR of 1.35:1 maximum, attenuation over 1-40 dB and 10 W of dissipation, all specified across the full DC to 18 GHz band rather than at spot frequencies. The in-line body sits between the two connectors and keeps the run straight, so the pad drops the level without adding a bend to the path. It is built in the Professional tier, the standard professional build for laboratory and production use.

Specifications

  • Interface: SMA, male to female
  • Attenuation: 1-40 dB
  • Power: 10 W
  • Frequency: DC to 18 GHz
  • Impedance: 50 ohm
  • VSWR: 1.35:1 maximum
  • Body: stainless steel
  • Weight: 0.05 kg
  • Grade: Professional

Where it is used

Calibration and verification set-ups use it to create known level steps without a programmable instrument. Production test uses it to standardise levels between stations, so a reading taken at one bench means the same at the next.

A fixed pad is also a diagnostic tool: insert it and the change in reading tells you how much of the error was level and how much was match.

DC to 18 GHz covers most laboratory traffic, from baseband through the lower microwave bands, and it is the range where this interface family has the deepest catalogue.

Compatibility and mating

It mates with standard SMA interfaces. The threaded coupling needs about 0.8 to 1.1 N·m; hand-tight plus a short wrench is enough, and overtightening is what deforms the dielectric and shifts the match.

The interfaces follow the series standard, so the pad fits any cable or port of that type; the value and the power rating, not the mating geometry, are what change between parts.

Store it capped. A mating plane that has collected grit will score the dielectric the first time it is torqued down.

Ordering

Custom builds are possible on the same interface pair: different plating, a different flange pattern or a longer body. State the requirement against this SKU and the factory will confirm what can be held.

Frequently asked questions

Does it need calibration?
No. A fixed pad has no adjustable parts; its value is set by the resistive element. Re-verify it only if a measurement looks suspicious.

How much power can it take?
The rating above is continuous, in free air. Derate it if the body is enclosed or sits next to another heat source, and never exceed it even briefly.

Can I get a different value?
The value range in the title is what this listing covers. Other values in the same family are separate SKUs; ask if you need a step that is not listed.

How do I mount it?
Most fixed pads hang on the connector. Heavier bodies have mounting holes; support the part so the connectors do not carry its weight.

Can it be used at higher frequency?
Only up to the rated band. Above it the element is no longer a pure resistance and the attenuation and match both drift.

R18S10-XX datasheet preview – click to view full PDF

Weight 0.05 kg
Dimensions 8 × 5 × 4 cm
Connector Type

Max Frequency

Reviews

There are no reviews yet.

Be the first to review “SMA Coaxial Fixed Attenuator | Professional, DC-18GHz, 10 W, 1-40 dB, Bidirectional, Male-Female, Round, Stainless Steel Connector”

Your email address will not be published. Required fields are marked *