For level control on a SMA path, R8S30U-XX provides 1-60 dB of fixed attenuation up to 8.5 GHz, in a 30 W package. The headline figures are a VSWR of 1.2:1 maximum, attenuation over 1-60 dB and 30 W of dissipation, all specified across the full DC to 8.5 GHz band rather than at spot frequencies. The in-line body sits between the two connectors and keeps the run straight, so the pad drops the level without adding a bend to the path. It is built in the Professional tier, the standard professional build for laboratory and production use.
Specifications
- Interface: SMA, male input, female output
- Attenuation: 1-60 dB
- Power: 30 W
- Frequency: DC to 8.5 GHz
- Impedance: 50 ohm
- VSWR: 1.2:1 maximum
- Body: stainless steel
- Weight: 0.05 kg
- Grade: Professional
Where it is used
Production test uses it to standardise levels between stations, so a reading taken at one bench means the same at the next. It protects front ends: a fixed pad in front of a sensitive input absorbs the mistake as well as the level.
A fixed pad is also a diagnostic tool: insert it and the change in reading tells you how much of the error was level and how much was match.
8.5 GHz sits well below the cut-off of the interface, so the match stays flat and the loss stays close to the minimum for the size.
Compatibility and mating
SMA is a 50 ohm threaded interface with a 1/4-36 coupling nut. Mate it finger-tight, then torque to roughly 0.9 N·m; the centre pin is small and dies quietly under a long wrench.
Nothing special is needed to mate it: clean the interfaces, torque to the figure for the series, and support the body so the connectors do not carry its weight.
Check the interface with a gauge after any drop. A part that has been dropped usually looks fine and measures badly.
Ordering
The SKU is the order code. If you need a different interface pair, a different gender combination or a longer body, ask before ordering rather than adapting this part on site.
Frequently asked questions
How much power can it take?
The rating above is continuous, in free air. Derate it if the body is enclosed or sits next to another heat source, and never exceed it even briefly.
Does it work in both directions?
A fixed pad is reciprocal: the attenuation is the same either way. Direction only matters on the variable and directional parts, where the title states it.
Can it be used at higher frequency?
Only up to the rated band. Above it the element is no longer a pure resistance and the attenuation and match both drift.
Why does it get warm?
It converts the removed power into heat. A warm body at rated power is normal; a hot body means the rating or the derating is being ignored.
Will it improve my return loss?
Yes, a pad isolates the two sides: a 6 dB pad improves the match seen by roughly 12 dB. That is why pads are used to stabilise a measurement.






![[Premium Pick] SMA Coaxial Fixed Attenuator | Professional, DC-26.5GHz, 2 W, 1-30 dB, Bidirectional, Male-Female, Round, Stainless Steel Connector](https://rfspect.com/wp-content/uploads/2026/09/R27S2-XX.png)
Reviews
There are no reviews yet.