RASP4S10-90-1 pads a SMA line down by 0-90 dB: a push-button variable 50 ohm attenuator, DC to 4 GHz, rated 10 W.
The pad is adjusted in 1 dB increments, so the level can be dialled in without swapping parts; a click per step keeps the setting readable on a busy bench.
Typical use is protecting a receiver or spectrum-analyser front end from an over-level signal, or setting a known level into a device under test.
FAQ – Will it change my VSWR? A fixed resistive pad actually improves the match seen by both sides, because the attenuating network absorbs reflections. The VSWR figure below is the number to design against.
FAQ – What happens above 4 GHz? The attenuation accuracy and VSWR are specified to 4 GHz; beyond that the pad will still attenuate but no longer to the printed accuracy.
Connect it the way the title states: input takes the source, output feeds the load. The rating difference between the two ends is deliberate.
The 10 W rating is a continuous rating with the body in free air; derate it if the pad is boxed up against other hot components.
Specified from DC to 4 GHz, the pad keeps its accuracy across the whole band rather than only at spot frequencies.
Key numbers: attenuation 0-90 dB; 10 W power; VSWR 1.3:1 max; 50 ohm impedance; nickel-plated brass body.
FAQ – Can I cascade two pads? Yes, and the dB values add. Check that the first pad’s power rating covers the incoming level and that the second sees a lower power, which it will.




![[Premium Pick] SMA Coaxial Fixed Attenuator | Professional, DC-18GHz, 2 W, 1-30 dB, Bidirectional, Male-Female, Round, Stainless Steel Connector](https://rfspect.com/wp-content/uploads/2026/09/R18S2X-XX.png)

![[Premium Pick] SMA Coaxial Fixed Attenuator | Professional, DC-26.5GHz, 2 W, 1-30 dB, Bidirectional, Male-Female, Round, Stainless Steel Connector](https://rfspect.com/wp-content/uploads/2026/09/R27S2-XX.png)
Reviews
There are no reviews yet.