, ,

N Male to L29 (DIN 7/16) Male Adapter | Economy, DC-7.5GHz, Brass with Tri-metal Plating

$37.00

+ Free Shipping
SKU: RA08N06-TBA Categories: , ,

A straight 50 ohm part, RA08N06-TBA converts an N male interface to an L29 (DIN 7/16) male interface across the DC to 7.5 GHz band.

Both ends are male, so it joins two ports or cables of the same sex; the part number states the pairing.

This band spans the usual L- through Ku-band bench work, where the adapter is a transparent part of the chain. The tri-metal plating stack on the brass body balances conductivity, wear resistance and corrosion protection.

Key numbers: VSWR 1.2:1 max; 50 ohm impedance; tri-metal plated brass body.

FAQ – What is the worst-case loss? The datasheet below lists maximum insertion loss; the datasheet figure applies across the band.

FAQ – Can I run it above 7.5 GHz? The part is specified to 7.5 GHz. Above that the VSWR and loss figures are no longer guaranteed, so treat it as out of band.

The straight body keeps the signal path axial, the shortest and lowest-reflection layout when the chassis has room. Systems integrators use it at the boundaries between subsystems, where two vendors rarely agree on the same connector.

FAQ – What torque should I use? Use the torque recommended for the interface standard of each end. Over-tightening is the usual cause of a damaged mating plane.

RA08N06-TBA datasheet preview – click to view full PDF

Weight 0.03 kg
Dimensions 6 × 3 × 3 cm
Connector Type

, ,

Max Frequency

Series

Reviews

There are no reviews yet.

Be the first to review “N Male to L29 (DIN 7/16) Male Adapter | Economy, DC-7.5GHz, Brass with Tri-metal Plating”

Your email address will not be published. Required fields are marked *