,

N Male Medium-Power Coaxial Termination | Professional, DC-12.4GHz, 25 W, Round, Ternary Alloy Plated Brass Connector

$255.00

+ Free Shipping
SKU: RT1225NM Categories: ,

RT1225NM is the medium-power N load in this range: 25 W rating, male interface, DC to 12.4 GHz.

The rating sits between bench pads and rack loads: the body carries enough metal to run at rated power for hours, with no fan and no derating curve below the limit.

Typical use is leaving an unused port terminated, dummy-loading a transmitter during alignment, or providing a stable 50 ohm sink at the far end of a line under test.

FAQ – What VSWR should I expect? The figure in the specs below is the guaranteed maximum across the band; a healthy termination typically measures better on the bench.

FAQ – Is ‘dummy load’ something different again? It is a third name for the same component: a connectorised resistor that soaks up RF power instead of reflecting it.

The round in-line body suits panel jacks and bench use, where it hangs on the port and convects freely.

From DC to 12.4 GHz the termination holds its VSWR figure; above the limit the match degrades, which matters if you rely on the load to absorb reflected power.

Key numbers: 25 W dissipation; VSWR 1.35:1 max; 50 ohm impedance; DC to 12.4 GHz; ternary alloy plated brass body.

FAQ – Does mounting orientation matter? For the finned bodies, yes: they are rated to convect with the fins vertical. Enclosing one or mounting it against a panel cuts the rating.

RT1225NM datasheet preview – click to view full PDF

Weight0.08 kg
Dimensions8 × 4 × 4 cm
Connector Type

Max Frequency

Reviews

There are no reviews yet.

Be the first to review “N Male Medium-Power Coaxial Termination | Professional, DC-12.4GHz, 25 W, Round, Ternary Alloy Plated Brass Connector”

Your email address will not be published. Required fields are marked *