The RT182TM is a TNC coaxial termination: male interface, 2 W of dissipation, specified from DC to 18 GHz.
At this power level a compact in-line body is enough; the load can stay on a port permanently without overheating the enclosure.
The round in-line body suits panel jacks and bench use, where it hangs on the port and convects freely.
From DC to 18 GHz the termination holds its VSWR figure; above the limit the match degrades, which matters if you rely on the load to absorb reflected power.
Key numbers: 2 W dissipation; VSWR 1.2:1 max; 50 ohm impedance; DC to 18 GHz; passivated stainless steel body.
It belongs on any port that would otherwise bounce energy back down the line: spare outputs, alignment set-ups, and the output side of amplifiers being characterised.
FAQ – Is ‘dummy load’ something different again? It is a third name for the same component: a connectorised resistor that soaks up RF power instead of reflecting it.
FAQ – What VSWR should I expect? The figure in the specs below is the guaranteed maximum across the band; a healthy termination typically measures better on the bench.
FAQ – Does mounting orientation matter? For the finned bodies, yes: they are rated to convect with the fins vertical. Enclosing one or mounting it against a panel cuts the rating.







Reviews
There are no reviews yet.