QMA Coaxial Load
QMA coaxial loads absorb forward power into 50 Ω DC to 4 GHz, with variants specified to 6 GHz. Two terminations are listed, from small in-line bodies to heatsink units rated 2 W.
Low-power parts are in-line cylinders; above roughly 25 W the body grows a heatsink, and at the top of the range an anti-pulse construction takes over for radar and pulsed duty. All of them use a QMA snap-lock joint.
• Frequency: DC to 4 GHz, with variants specified to 6 GHz
• Impedance: 50 Ω nominal
• Power: 2 W
• Interface: QMA snap-lock
• Gender: male versions
• Body / plating: ternary-alloy plated brass bodies
Loads terminate unused ports on a divider or switch, absorb power at the end of a test line, and protect a source from running into an open circuit. Size the body from average power with margin for pulse duty and for the way it is mounted.
Frequently asked questions
How do I size a QMA load?
Start from the highest average power the port will deliver, then add margin for reflected power and for the mounting. The listed range runs 2 W; above that, a heatsink body or forced air is needed rather than a small in-line part.
Can a load be used to measure power?
No. A load absorbs power, it does not measure it. Measurement needs a power sensor, or a load plus a directional coupler and a calibrated sensor.
Does a load need a heatsink or airflow?
Above a few watts, yes. In-line bodies rely on free convection, so mounting them against a panel, inside a closed rack or in a hot ambient reduces the rating. High-power loads are built around a heatsink for exactly that reason.
See also QMA attenuators, N Coaxial Load, SMA Coaxial Load, TNC Coaxial Load and 2.92mm Coaxial Load.
Showing all 2 results


