M Adapter

UHF (M-type) adapters are the shortest way to change gender, series or direction on a UHF (M-type) line. RFSPECT lists two configurations here, all 50 Ω and specified DC to 3 GHz, with transitions to N and M.

Every part uses a UHF (PL-259 / SO-239) joint, the legacy HF/VHF interface, and is built as one 50 Ω assembly. That matters on a bench: a two-piece lash-up adds a junction, and a junction adds reflection exactly where the measurement is most sensitive.

• Frequency: DC to 3 GHz
• Impedance: 50 Ω nominal
• Interface: UHF (PL-259 / SO-239)
• Transitions: UHF (M-type) to N and M
• Gender: male-to-female
• Body / plating: nickel-plated brass bodies
• Grades stocked: Economy

Typical work is a test bench that has to move between UHF (M-type) and N: instrument ports, DUT fixtures, and cable assemblies already terminated in another series. Match the grade to the job — Precision and Ultra parts for calibration and millimeter-wave measurements, Economy parts for production patching.

Frequently asked questions

Can a UHF (M-type) adapter be used in either direction?
Yes. An adapter is a passive reciprocal two-port, so it works the same way round; only the connector genders decide which end goes where. A UHF (M-type) line does not care which side the signal arrives from.

How do I choose between Precision, Ultra and Economy grades?
Precision and Ultra parts are machined to tighter concentricity and belong inside calibration paths and millimeter-wave measurements. Economy parts use the same interface geometry in a lower-cost body, which suits production lines, incoming inspection and general patching.

Will an adapter damage a mismatched port?
No. The risk is mechanical, not electrical: repeatedly mating an adapter with a worn or dirty interface is what wears a port out, which is why a sacrificial adapter on an instrument is cheaper than a repair.

See also N Adapter, SMA Adapter, 2.92mm Adapter, 3.5mm Adapter and RF adapter overview.

Showing all 2 results