SSMA Coaxial Load
SSMA coaxial loads absorb forward power into 50 Ω DC to 40 GHz. Four terminations are listed, from small in-line bodies to heatsink units rated 0.5 W to 2 W.
Construction follows power: an in-line cylinder for a few watts, a finned body for tens of watts, and a heavy rectangular block where the load has to sit in a rack for hours. The joint is 10-36 UNF threaded on every part.
• Frequency: DC to 40 GHz
• Impedance: 50 Ω nominal
• Power: 0.5 W to 2 W
• Interface: 10-36 UNF threaded
• Gender: male and female versions
• Body / plating: passivated stainless steel bodies
Loads terminate unused ports on a divider or switch, absorb power at the end of a test line, and protect a source from running into an open circuit. Size the body from average power with margin for pulse duty and for the way it is mounted.
Frequently asked questions
Can a load be used to measure power?
No — a load absorbs the power without indicating it. To measure, use a power sensor, or sample the line with a directional coupler into a sensor.
Does a load need a heatsink or airflow?
Above a few watts, yes. In-line bodies rely on free convection, so mounting them against a panel, inside a closed rack or in a hot ambient reduces the rating. High-power loads are built around a heatsink for exactly that reason.
How do I size an SSMA load?
Start from the highest average power the port will deliver, then add margin for reflected power and for the mounting. The listed range runs 0.5 W to 2 W; above that, a heatsink body or forced air is needed rather than a small in-line part.
See also SSMA attenuators, N Coaxial Load, SMA Coaxial Load, TNC Coaxial Load and 2.92mm Coaxial Load.
Showing all 4 results




