APC-7 Adapter
These ten APC-7 adapters keep a 50 Ω line intact DC to 18 GHz, moving APC-7 onto SMA, N, 3.5mm and 2.4mm without adding a cable and a second junction.
The mating interface is sexless 7 mm — the metrology standard that has no gender at all. Because each part is machined as a single body rather than assembled from a connector plus a barrel, the centre pin stays concentric under torque and VSWR stays low across the band.
• Frequency: DC to 18 GHz
• Impedance: 50 Ω nominal
• Interface: sexless 7 mm
• Transitions: APC-7 to SMA, N, 3.5mm and 2.4mm
• Gender: male-to-male and female-to-female
• Body / plating: passivated stainless steel bodies
• Grades stocked: Economy
Use them to protect an instrument port from repeated mating, to convert a fixture to the connector the DUT actually has, or to join two cables of different series. The grade should follow the tolerance the measurement needs, not the price of the part.
Frequently asked questions
Can an APC-7 adapter be used in either direction?
Yes. An adapter is a passive reciprocal two-port, so it works the same way round; only the connector genders decide which end goes where. An APC-7 line does not care which side the signal arrives from.
What frequency range do APC-7 adapters cover?
DC to 18 GHz. The ceiling is set by the APC-7 interface, so an APC-7-to-APC-7 body reaches the full rating while a transition to a lower-frequency series is limited by the weaker of the two interfaces.
How do I choose between Precision, Ultra and Economy grades?
Grade tracks mechanical tolerance, not interface type. Take Precision or Ultra when the adapter sits in a calibration path or above 26 GHz, and Economy when it is there to save a connector from wear on a production line.
See also SMA Adapter, N Adapter, 2.92mm Adapter, 3.5mm Adapter and RF adapter overview.
Showing all 10 results










